• This web page was last updated on Mon, 2014 May 12 @ 0158 hours
• Questions about this page? Contact us by email.

All Wulfden Freeduino kits (RBFK328, EDucatoBBB, RBBB, DorkBoard) come with an ATMega328P with Arduino Uno bootloader burned in. "Setup" is nothing more than selecting the Uno as the board type. Typical setup for Arduino IDE version 1.0 would be;

• Open Arduino
• select for 'board' "Arduino UNO"
• select for 'serial port' whatever COMport you are hooked to
• open a sketch
• select File-->Upload

Educato Kit - has all the surface mount parts mounted and tested by Paul and the guys at Modern Device. The remaining through parts have to be mounted and soldered and the completed board tested.

• The story of the Educato and some subtle details about the board. It was last updated on Thu, 2014 May 08 @ 2032 hours
• The schematic and assembly instructions for the Educato board are available. It was last updated on Thu, 2014 May 08 @ 2040 hours

Educato Kit bundled with 830 hole breadboard, bundle of wires, mini-B USB cable

Educato Kit
Only

Educato Kit Bundle

9 vdc/300 ma AC Power Supply - this a like-new "pull" from never used equipment. It was designed to be plugged in 24/7. Has standard 18 ga wire with standard coaxial connector. (Radio Shack Type "M" - 2.1 x 5.5 mm) 000